Halloween season is calling and what better way to spend it than making your very own flubber! Fun for all occasions however children should be supervised by an adult.

You Will Need:

• 1 1/2 Water
• 2 Cups PVA Glue
• Food Colouring
• 1 1/3 Water
• 3 Teaspoons Sodium Tetraborate (Borax) 5% Solution

STEP 1

In a container mix 1 1/2 cups warm water, white glue and a few drops of food colouring. Top Tip: Since this is for the Halloween season work with orange, red or purple for a spooky effect!

STEP 2

In a second container mix 1 1/3 cups warm water and 3 Teaspoons of Sodium Tetraborate (Borax) 5% Solution.

STEP 3

Mix the Sodium Tetraborate (Borax) 5% Solution mixture into the glue mixture until combined. Please Note: After mixing their may be some mixture in the bottom of the container, don’t worry about this).

STEP 4

Place Flubber on a tray and allow this to stand for a few minutes, once this time has gone you can begin playing with it!

STORAGE

Store in a air tight container for maximum use.

*Children should be under supervision throughout this experiment. Handle this chemical with a lot of caution including using safety goggles, gloves, apron and wearing appropriate clothing and shoes. We do not accept any responsibility for participating in this experiment*

NOTE: BEFORE USING ANY OF THE PRODUCTS LISTED PLEASE READ ANY SAFETY AND PRECAUTIONS TO THIS PRODUCT BEFORE USAGE. 

PLEASE ALSO COMPLETE A PATCH TEST.

APC Pure does not accept any responsibility, this is a guide only.